Properties of Access Points (APs)

The APs can be moved about to any location on the deployment panel by clicking and dragging with the left mouse button. When an AP is highlighted, its characteristics can be seen on the AP Tree and the Configurtion and Statistics charts on the left and right sides of the screen. Alternatively, you can right click on an AP to see its characteristics as well as to delete it.

Note that some of the APs may be lightly shaded. These are Shadow APs  located on other floors but whose signals are leaked to the current floor.

If you want to add an AP, click and drag the Add AP icon  down from the button tool bar.

You can select multiple APs by clicking APs with Ctrl-key pressed down. Then you have the capability to move, delete or set their properties as a group. This is the so-called group mode for APs.

You can select all the walls to apply the changes at once by selecting All Walls under the system pop-up.

Note that in addition to AP properties, the AP Summary dialog box is also where you set the requirements such as the number of supported clients and the required load for each client.